Formula 233 Registry

The premier site for owners of the famous 233.

Hi All

Well the day finally came to sea trail my new EdenCraft 233 Formula.  A little background first.  I took a slightly different track with my 233, instead of the normall twin engine setup I choose a single Yamaha 350.  Along with the massive V-8  I asked the fine folks at Edencraft to "Notch" my transom which equate to a better flow of water to the engine with less drag.

Test was done with 2 adults in the boat and 550 liters of fuel aboard.  I have 3 AGM batteries in the rear and a Stainless Steel Large "X Winch" up forward.  Wind was blowing 12-15kts. Propeller is 16.5" X 19" 4 Blade PowerTech.

Top speed was 48 kts or (92 Km/h, 55 Mph) at 5500 rpms.  The boat just purred along at 30 Kts which was 3600 rpm while burning 60 liters per hour.

Very happy with the notch, while the boat was running at planning speed no spray and it left a very clean wake.

Well I hope this help future 233 owners if you have any questions just ask away.

 

Rick

Views: 1371

Attachments:

Reply to This

Replies to This Discussion

Great looking set up there!!! I am interested in the bunks on the trailer,any info you can share about them would be appreciated as  I am in the process of building up a trailer for mine.

Regards Doug

Hi Doug

The trailer was built by Float On Corporation in Florida.  Those bunks are pattened to Float On.  As you can see they are extruded aluminum that tilt to any deadrise.

Contact Tim at Float On as I not sure if they sell them.

Rick

Thanks for the detailed report. Sounds like a very successful first outing!

Thanks Dave

Sure no worries on the pics.  This time I just wanted to find out about the notch and motor height.  The SeaStar Tournement Cylinder developed a rubbing noise and now SeaStar wants it back for testing they are sending me another out. 

As you can see my boat is pretty "barebones" compared to yours I would imagine your rig is quite a bit heavier than mine.  Mine will slow down when we start adding "Bits and Bobs".  Really I only care about that 30-36 kts speed.  I love the fact that at 30 kts you can walk around the boat and have a conversation without shouting or hanging on for dear life.

Cheers Dave

Rick

Rick, 

This turned out really nice!  When you have the time, could you please post up some dimensions of the notch that Edencraft installed for you?  Thank you in advance!

Henry

Hi Henry

The notch design is 36" (900mm) wide X 8" (200mm) high off centerline X 10" (250mm) deep or into the hull.  Make sure all corners have a good radius.  

I mounted my engine at  minus 3" (75mm) above the keel.

Rick

Attachments:

hi rick great to see her finished and aren't those Yamaha outboards great?? i like the step in the hull and the engine height advantage. have you got any side on photos of the hull??

thanks jim

Hi Jim

You mean of the notch or in the water??  We are still waiting to take some water photo's but they will be coming soon.  If you want a side profile of the notch than no problem.

Rick

PS:  Yes I love my Yamaha, she is not even breathing hard pushing 3 tons around !

RSS

Badge

Loading…

© 2024   Created by David.   Powered by

Badges  |  Report an Issue  |  Terms of Service